How many accessible stalls your lot needs
Accessible stall counts scale with the total number of spaces in the lot. For smaller lots the ratio is roughly one accessible space for every 25 total spaces, then the ratio steps down as lots get larger.
- 1 – 25 total spaces: 1 accessible space
- 26 – 50: 2 accessible spaces
- 51 – 75: 3 accessible spaces
- 76 – 100: 4 accessible spaces
- 101 – 150: 5 accessible spaces
- 151 – 200: 6 accessible spaces
- 201 – 300: 7 accessible spaces
- Above 300, counts continue to step up on a reducing ratio
Van-accessible spaces
At least one of every six accessible spaces must be van accessible, and a lot with only one accessible space must make that space van accessible. Van stalls pair with a wider access aisle so a side-mounted lift has room to deploy, and they carry an additional van-accessible sign.
Stall and access aisle dimensions
- Car accessible stall: 8 feet wide minimum
- Van accessible stall: 8 feet wide with a 8-foot access aisle, or 11 feet wide with a 5-foot aisle
- Standard access aisle beside a car stall: 5 feet wide minimum
- Access aisles must be marked so they are not mistaken for parking
- Two accessible stalls may share a single access aisle
- Aisle length must run the full length of the stall it serves
Location and the accessible route
Accessible spaces must be on the shortest accessible route to the accessible entrance. That is a real design constraint, not a formality — a stall placed far from the door, or one whose route crosses a curb with no ramp, does not comply even if the paint is perfect.
Surface slope matters as well. Accessible stalls and their aisles need to be relatively flat in all directions. On sloped lots like those in Fall River or Norwich, stall placement is often dictated by where the grade is gentle enough.
Signage
Each accessible space needs a sign displaying the international symbol of accessibility, mounted so the bottom of the sign sits at least 60 inches above the ground — high enough to stay visible when a vehicle is parked in the space. Van spaces add a van-accessible designation.
A pavement symbol alone does not satisfy the signage requirement. It is a useful visual cue, but the post-mounted sign is what is actually required.
The five mistakes we correct most
- Access aisle painted too narrow, usually 3 or 4 feet instead of 5 or 8
- No NO PARKING marking in the access aisle, so it gets parked in
- Missing van-accessible stall in a lot that has several accessible spaces
- Signs mounted too low, or knocked down by a plow and never reset
- Accessible stalls placed at the far end of a lot rather than nearest the entrance
Getting compliant quickly
Most compliance problems are fixable in a single visit, because they are layout and marking issues rather than construction. We measure your total stall count, determine the required number of accessible and van-accessible spaces, re-snap the stalls and aisles to correct widths, re-stencil the symbols and lettering, and set signage to height.
This guide is a plain-language summary, not legal advice. Local building officials and your state's accessibility code can impose additional requirements, and we confirm those before laying out your lot.