Seal first, stripe second — always
Sealcoat covers everything, including your lines. If you stripe first and seal after, you pay for striping twice. The correct sequence is sweep, repair, sealcoat, cure, then stripe.
The same logic applies to paving. New asphalt should cure roughly 30 days before striping so surface oils release and paint can bond. Striping fresh asphalt too early is the most common cause of paint that lifts within a season.
How long to wait
- New asphalt before striping: about 30 days
- Fresh sealcoat before striping: 24 to 48 hours in warm, dry weather
- Sealcoat before vehicle traffic: 24 hours minimum
- Crack filling before sealcoat: same day is usually fine
- Paint before traffic: 30 to 60 minutes
Preserving the layout before it disappears
Before sealer goes down, the existing layout should be documented: overall photos, stall counts, and reference measurements from fixed features like curbs, islands and light poles. Without that, the striping crew is designing a new layout after the fact — and the stall count can come out different from what you had.
We measure and photograph before sealcoating whenever we are handling the striping side, so the lot comes back exactly as it was, or intentionally better.
Fitting both into a New England season
Sealcoating and striping both need warm, dry pavement, which compresses the calendar to roughly May through early October here. Because you need a cure window between them, plan the pair as a single project with two visits a few days apart rather than two separate jobs months apart.
Book early. The best contractors in Rhode Island fill their sealcoat and stripe calendar by midsummer.